You might notice it in the blue of the sky or the white of a wedding dress. Maybe, as often happens with me, it’s the petals of a flower. Whatever the image, someday you’re going to look closely at a picture and see that it’s full of little spots. These often look like little dark spots ringed by a color that’s slightly lighter than the background, and they show up in the same place on every picture you take.
These spots usually come from dust on your sensor. You won’t see them too often at large apertures, but when you stop the camera down they start to become visible. They particularly stand out in areas that have large expanses of a single light color, but you can often see them in other areas of the image as well.
This flower was taken at f/32, which as we all know is a very tiny f-stop. It’s not a great photo, but because of the small aperture it shows every little piece of dust on the sensor. You can’t really see it at the small size, but if you were to look at the full-resolution image you’d see lots and lots of little bitty spots all over the photo.
There’s an easy way to test to see if you have noise on your sensor. Find a brightly-lit white or light-colored wall, or a piece of plain white paper. Set your camera to manual mode, shutter speed of about two seconds, and the smallest aperture your lens will do. Point the camera at the white surface and take a picture, moving the camera around just a little bit so that the background becomes blurry.
This image originally came from Flickr user djwudi, and I thank him for allowing me to use it. He works in a camera shop, and a customer came in complaining about spots on his photos. This is what the sensor looked like at f/32 before cleaning. I’ve personally never seen one this bad, but dust can start making your pictures ugly long before this point.
If you change lenses, and sometimes even if you don’t, getting dust on your sensor is inevitable. However, there are a few things you can do to reduce the amount of dust that your sensor collects:
- Never store the camera without a lens or other protective cap
- Minimize the number of times you change lenses, and minimize the amount of time the lens is off the camera
- When you change lenses, make sure the body of the camera is pointed down and the camera is turned off
- Try not to change lenses in dirty environments
My procedure for changing lenses is to turn the camera off (though sometimes I forget), then take the rear cap off of the new lens and get it ready to go. As soon as it is, I point the camera straight down, remove the lens, and put the new one on as quickly as possible. I then put the rear cap on the old lens and store it in my camera bag.
Do you have dust? Don’t worry! Here are SSA!’s instructions for cleaning your sensor.